User's Guide _______________________________________________________________________
36 ___________________________________________________________________ M211107EN-C
Mounting to Existing Surface
To mount the FS11P system to an existing surface, proceed as follows:
1. If Background Luminance Sensor LM21 is installed, align any of
the three sides so that the LM21 bracket allows the desired viewing
direction for LM21, and place the template on top of the existing
foundation.
2. Drill three ∅20 mm holes with a depth of 100 to 260 mm using the
drilling template. Remove the template. Clean the holes.
3. Fasten the foundation screws to the wedge bolts by hand.
4. Protect the tops of the screws with two nuts tightened together.
5. Place the wedge bolt and foundation screw combinations in the
holes, wedge bolts down. Refer to Figure 8 below. Hammer the
combinations down until the wedge bolts attach to the walls of the
holes.
6. Tighten the foundation screws as tight as possible.
0203-001
Figure 8 Mounting FS11P to Existing Surface
The following numbers refer to Figure 8 above:
To Next Page
Loading...
