Vaisala FS11P - Date; Reset; Ver

Chapter 4 _________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 125
To set the time, use the following command:
TIME hh mm ss
where
hh
=
Hours
mm
=
Minutes
ss
=
Seconds
DATE
The DATE command is used to display the current date.
To set a new system date, type the following:
DATE yyyy mm dd
where
yyyy
=
Year
mm
=
Month
dd
=
Day
NOTE
The time and date are only valid if restored manually after
the power has
been off.
RESET
The RESET command makes a hardware reset by the watchdog
circuitry.
VER
The VER command shows the version of the software.