User's Guide ______________________________________________________________________
132 _________________________________________________________________ M210667EN-C
Startup Procedure
LT Maintenance Interface
Connection to Maintenance Terminal
Any computer equipped with terminal emulation software or a VT100-
compatible terminal with an RS-232 serial interface can be used as a
maintenance terminal for LT31. The maintenance cable QMZ101
(included in the delivery) provides a 9-pin D connector for the computer
and a connector for LT31. The external maintenance connector of LT31
is located at the right side of the receiver interface unit (see Figure 89
below). The connector is protected with a cap. Replace the protective cap
after disconnecting the maintenance cable. LT maintenance interface is
shown in Figure 90 on page 133.
0401-124
Figure 89 External Maintenance Line Connector
To Next Page
