User's Guide ______________________________________________________________________
156 _________________________________________________________________ M210667EN-C
Menu-driven Operation
Operational actions which are necessary for installation, such as,
configuration, alignment, calibration, maintenance, and troubleshooting,
can be undertaken in the so called menu-driven mode. You can enter this
mode by typing the MENU command at the user or advanced level.
NOTE
The menu-driven operation is designed for VT100 terminal with 80
columns. For proper operation, the terminal height in lines used by the
terminal application must be configured to LT31 with the command
SET TERMINAL_LINES number (minimum 24). In addition, any 'line
wrap'- and 'translate CR or CR/LF'-option must be switched off for the
terminal application in use.
The Main Menu is shown in Figure 102 below.
0803-001
Figure 102 Main Menu
The following characters refer to Figure 102 above.
A =
Enter Configuration menu
B = Enter System Status menu
C = Enter Alignment menu
D = Enter Calibration menu
E = Enter Linearity Test menu
F = Enter Simulation menu
G = Enter PWD Sensor menu
H = Enter Service menu
I = Enter Events menu
Entering submenus is done by using one-character commands. The valid
one-character commands are listed in each menu by a character enclosed
To Next Page
Loading...
