Chapter 4 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 99
1104-096
Figure 54 LT31 with LM21 Option Installed
The following numbers refer to Figure 54 above.
1 = Transmissometer LT31
2 = Background Luminance Sensor LM21F
3 = Mounting bracket
4 = Support arm
5 = Fastener assembly
To install the optional LM21 proceed as follows:
1. Route the LM21 cable (with open wire ends) through the hole in
the rotation plate of the mounting bracket so that the connector is
finally located as shown in Figure 55 on page 100.
To Next Page
Loading...
