Chapter 4 _______________________________________________________________ Installation
VAISALA _______________________________________________________________________ 97
5. Now place the ladder behind the receiver mast and check the
orientation of the support unit.
6. Loosen the two fastening screws (hex socket, size 4) at the right
side (operator's view) of the mast top. The complete support unit
must now be turnable. See Figure 52 below.
0401-076
Figure 52 Fastening Screws of Support Unit
7. Align the support unit horizontally to the position where the
transmitter mast will be located in the future. Use the sight hole in
the rear plate together with the sight. See Figure 53 on page 98.
To Next Page
Loading...
