Vaisala LT31 - Beep; Freq (Advanced Command Level Only); Heat; Mrdc (Receiver Only) (Advanced Command Level Only)

User's Guide ______________________________________________________________________
252 _________________________________________________________________ M210667EN-C
Heat
ON Heater is switched on.
OFF Heater is switched off.
Beep
??? Status of acoustical signal is unknown.
ON Acoustical signal is generated. Pattern of acoustical signal is
dependent of Main Receiver Signal Value. See section
Alignment on page 225.
OFF
Acoustical signal is not generated.
Status
The transmitter and the receiver part of the overall status is displayed.
For message decoding, see section Status Codes on page 164.
Freq (Advanced Command Level only)
Transmitter Generated Main Transmitter Modulation Frequency.
Receiver Detected Synchronization Signal Frequency.
This may differ from the generated Main Transmitter
Modulation Frequency but must be in the same range.
Frequency values are updated only when any frequency command has
been invoked.
mRdc (Receiver only) (Advanced Command Level only)
Main Receiver DC value (0-1023)
mTint (Transmitter only) (Advanced Command Level only)
Main Transmitter Intensity value (0-1023)
mTdera (Transmitter only) (Advanced Command Level only)
Main Transmitter derating value (0-1023)
wRdc (Advanced Command Level only)
Window Receiver DC value (0-1023)
wTint (Advanced Command Level only)
Window Transmitter Intensity value (0-1023)