Vaisala LT31 - Figure 130 Scanning Axes During Raw and Fine Alignment

User's Guide ______________________________________________________________________
230 _________________________________________________________________ M210667EN-C
To confirm, type yes<CR>.
To abort the action, type no<CR>.
From now on, the acoustic signal is switched off. To continue, a
confirmation to start fine alignment has to be given.
Start Fine Alignment? (yes/no):
To confirm, type yes<CR>.
To abort the action, type no<CR>.
Now all the axes are scanned to find the position of axis for the highest
main receiver signal available, one by one. Indication of the process is
given on the left of the menu. On the right, the current positions and the
main receiver signal are changing according to the ongoing process. In
the lower part, found positions for the highest main receiver signal are
displayed after each scan.
0401-114
Figure 130 Scanning Axes during Raw and Fine Alignment
The user is requested to start calibration procedure immediately.
NOTE
A Signal indication of at least 60 % is recommended to be achieved after
the fine alignment procedure is finalized. Otherwise please doublecheck
the raw alignment.
NOTE
It is highly recommended to perform calibration procedure after fine
alignment.
Proceed with Calibration? (yes/no):