User's Guide ______________________________________________________________________
254 _________________________________________________________________ M210667EN-C
Commands
Nearly every command is selected, specified and invoked by one-key
commands. Once the user has selected a command (A-G, A-C for the
user command level), the command has to be specified in further detail.
Available choices for a specification are given in the lower area of the
Service menu when a command has been selected.
Blower
The blower can be switched on or off for the transmitter or receiver unit.
Select the command by pressing
A.
The user has to select whether to handle the transmitter or receiver unit.
BLOWER (R)ECEIVER/(T)RANSMITTER
The transmitter unit blower is selected by pressing T.
The receiver unit blower is selected by pressing
R.
The user has to select whether the blower shall be switched on or off.
BLOWER TRANSMITTER O(N)/OF(F) or
BLOWER RECEIVER O(N)/OF(F)
The blower is switched on by pressing N.
The blower is switched off by pressing
F.
The result can be read at the displayed values at Blow.
Example: On the user command level, the receiver unit blower shall be
switched off. See Figure 148 on page 255.
To Next Page
Loading...
