User's Guide ______________________________________________________________________
136 _________________________________________________________________ M210667EN-C
Table 9 Default Settings
Setting Default
Transmission rate 9600 bps
Communication parameters 8N1
Mode RS-232
Polled or automatic mode,
message type
Automatic mode, message 2, interval
10 seconds
Message port Data
Baseline 30 m
Sensor ID No ID set
In multipoint communication where several sensors share the same
communication line (RS-485/Modem), LT31 must be used in the polled
mode and the individual sensors must have distinct identifiers (ID).
You can check/set the basic configuration parameters of the LT31 in an
easy way. Select the maintenance menu by first typing the OPEN
command as explained above and then the MENU command. See Figure
92 below.
0803-001
Figure 92 Main Menu
To Next Page
Loading...
