User's Guide ______________________________________________________________________
284 _________________________________________________________________ M210667EN-C
0401-069
Figure 153 Frangible Mounting Rod and Foundation
Screws
8. Insulate the area between the frangible mounting rod/foundation
screw and foundation surface below the washer with silicon rubber,
so that water cannot get to the drilling hole.
9. Tighten the frangible mounting rod/foundation screws using the
welded nut (60 Nm; maximum 80 Nm).
10. Make sure that the screw positions fit by using the drilling
template.
Setting Up Receiver/Transmitter Mast to
Foundation
NOTE
In case the LT31 Receiver Unit is installed using an extension pole
LTEP100/200, the following instruction replaces the section Setting up
Receiver M
ast to Foundation on page 94.
In case the LT31 Transm
itter Unit is installed using an extension pole
LTEP100/200, the following instruction replaces Section Setting up
Receiver M
ast to Foundation on page 110.
To Next Page
Loading...
