User's Guide ______________________________________________________________________
138 _________________________________________________________________ M210667EN-C
- For the data port, the Speed and Format must correspond with the
peripheral equipment.
- For the data port, Mode has to be selected according to the used
interface connections on the LTC212 (RS232 or RS485).
- Configure the desired modem Mode in the module section if the
optional DMX501 modem is installed.
NOTE
To exit the MENU pages, press ESC.
Checking Operation
Pressing B on the keyboard on the MAIN MENU page gives access to
the LT31 System Status page (see Figure 94 below).
0401-131
Figure 94 System Status
TRANSMITTER must indicate OK in all positions.
RECEIVER must indicate OK in all positions.
PWD Sensor must indicate OK.
LM Sensor must indicate OK, when installed (optional).
SPECIALS are to be indicated as OK after the final alignment and the
calibration were successfully carried out. For details on fine-alignment
and calibration, see sections Fine Alignment on page 231 and Section
Calibration on page 232.
NOTE
To exit the MENU pages, press ESC.
To Next Page
Loading...
