User's Guide ______________________________________________________________________
260 _________________________________________________________________ M210667EN-C
Receiver Response Time (Advanced Command Level
Only)
The Main Receiver Response Time can be switched to slow or fast.
Select the command by pressing
G.
The user has to select whether to switch the Main Receiver Response
Time to slow or fast.
RECEIVER (F)AST/(S)LOW
The Main Receiver Response Time switched to fast by pressing F.
The Main Receiver Response Time switched to slow by pressing
S.
The result can be read at the displayed values at mRac.
Example:
On the advance command level the Main Receiver Response Time will
be switched to fast (see Figure 151 below).
1104-117
Figure 151 Setting Main Receiver Response Time to Fast
To Next Page
Loading...
Need help?
General
