Vaisala LT31 - Figure 50 Mounting Weather Protection Hood; Figure 51 Cable Routing for Optional Heated Hood

User's Guide ______________________________________________________________________
96 __________________________________________________________________ M210667EN-C
To set up the weather protection unit:
1. Place the ladder in front of the receiver mast.
2. Then install the weather protection hood.
3. Fix the hoods with two screws (hex socket head, size 3) at each rear
end corner of the hood. See Figure 50 below.
0401-073
Figure 50 Mounting Weather Protection Hood
WARNING
Death or serious injury may occur!
The AC power voltage must be disconnected from the instrument.
Otherwise, switch the AC power off.
4. In case a heated weather protection hood is used, lay the heater
cable inside the support unit as shown in Figure 51 below.
0401-075
Figure 51 Cable Routing for Optional Heated Hood