User's Guide ______________________________________________________________________
84 __________________________________________________________________ M210667EN-C
0201-071
Figure 41 Installing DMX501
The following number refers to Figure 41 above.
1 = DMX501 Modem module
NOTE
Handle the boards carefully. Do not touch the components on the boards
to avoid ESD damage to them. Ground yourself before attempting to
touch the boards.
NOTE
Do not let the boards get wet.
NOTE
Note the correct orientation of the DMX501 module.
6. After installing the DMX501 modem, push the LTC212 board back
to its place and attach the two screws securing it into the correct
position.
7. Attach the cover plate by tightening the four screws holding it.
8. Insert the connectors onto the LTC212 board and note their correct
order (refer to the numbers on the cover plate).
9. Make the necessary signal wiring as described above and turn on
the AC switch and also the battery backup switch if installed).
To Next Page
Loading...
