Vaisala LT31 - Movement (Advanced Command Level Only)

User's Guide ______________________________________________________________________
258 _________________________________________________________________ M210667EN-C
Movement (Advanced Command Level only)
CAUTION
Changing positions of the optics units may result in loss of performance
to the LT31 system. Only trained or advised users shall use this feature
The horizontal and vertical position of the optics unit can be changed for
the transmitter or receiver unit.
Select the command by pressing
E.
CAUTION
The transport protection in the transmitter and receiver measurement
unit have to be removed before moving any optics.
Make sure that the transport protection in the transmitter and receiver
measurement unit have been removed. The user has to give a
confirmation.
HAS THE TRANSPORT PROTECTION IN THE T/R OPTIC UNITS BEEN
REMOVED? (yes/no) :
To confirm, type yes<CR> .
To abort the action, type
no<CR>.
The user has to select whether to handle the transmitter or receiver unit.
MOVE (R)ECEIVER/(T)RANSMITTER
Moving a transmitter optics unit is selected by pressing T.
Moving a receiver optics unit is selected by pressing
R.
The user has to select whether to move horizontal or vertical axis.
MOVE TRANSMITTER (H)ORIZONTAL/(V)ERTICAL or
MOVE RECEIVER (H)ORIZONTAL/(V)ERTICAL
Vertical movement is selected by pressing V.
Horizontal movement is selected by pressing
H.
The user has to give the position to reach by its value.
GIVE VALUE (100...900):
Type the position to reach and terminate the input by <CR>.
The result can be read at the displayed values at ver resp. hor.