Vaisala LT31 - Message 3 - Status Message

Chapter 5 ________________________________________________________________ Operation
VAISALA ______________________________________________________________________ 175
The total amount of characters in the message is 140. The transmission
times are: 4.7 s at 300 bps (10-bit char), 0.58 s at 9600 bps.
For visibility alarm/status code explanations, refer to Table 13 on page
164.
For background luminance alarm/status code explanations, refer to Table
34 on page 173.
For PWD alarm/status code explanations, refer to Table 33 on page 173.
Message 3 - Status Message
The status message contains the results of the built-in tests. These
numerical internal monitoring measurement values can be requested with
the STATUS command. The short status check message which contains
a short, clear language report of the system status can be requested with
the STATUS CHECK command. The following is an example of a
status message:
!LT1" LT31 SYSTEM: OK
Status: 02000000000000000000
Interface unit:
Temperatures (unit C):
CPU: 32.7 external://///
Humidity:////
Voltages:
+12V: 11.8 +12Vout: 0.5 PVin: 20.8 V5I: ON
Transmitter unit: OK
Status
EEPROM:00 TEMP:00 ALIGN:00 MISC:00
HEATER:H BLOW:0
Temperatures (unit C):
Heater:+48.2 Enclosure:+42.9
WinRec:+43.7 WinTrm:+43.6 MainTrm:+41.1
Receiver unit: OK
Status
EEPROM:00 TEMP:00 ALIGN:00 MISC:00
HEATER:H BLOW:0 REC:S
Temperatures (unit C):
Heater:+51.0 Enclosure:+41.4
WinRec:+41.9 WinTrm:+43.2 MainRec:+37.9
PWD Sensor: OK
PWD STATUS
VAISALA PWD21 V 1.01 2001-11-01 SN:W42106 ID STRING: 0
SIGNAL 0.53 OFFSET 160.77 DRIFT 7.52
REC. BACKSCATTER 993 CHANGE 58
TR. BACKSCATTER -1.2 CHANGE -0.0
LEDI 2.6 AMBL -1.1
VBB 15.2 P12 11.5 M12 -11.3
TDRD 7 DRD 800 DRY 815.1
TS 5.5 TB 10
HARDWARE :