User's Guide ______________________________________________________________________
90 __________________________________________________________________ M210667EN-C
1. Screw on the three reinforcing plates to the lower end of the
foundation screws as in Figure 45 on page 91. To prevent the plates
from rotating after their correct position has been found, destroy
the threads above and below them by hammering.
2. Fix the drilling template to the upper ends of the foundation screws
with six M16 nuts.
3. Embed the assembly in the concrete foundation as shown in Figure
45 on page 91. Be sure to align the assembly taking the optical axis
of LT31 into account as shown in the figure (orientate the assembly
in such a manner, that one of the foundation screws points exactly
towards the opposite installation place).
4. After the concrete has set, remove the template.
To Next Page
Loading...
