EasyManuals Logo

Vanderbilt lite blue User Manual

Vanderbilt lite blue
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #122 background imageLoading...
Page #122 background image
VLBIM06/15/15 v4.1.0
Chapter 9 Schlage Wireless Readers 121
Wireless Reader Interface (WRI Indoor or Outdoor)
The WRI-IN/OUT-12VDC acts as a remote card reading device that communicates via RF with lite blue through a
mating Panel Interface Module (PIM). The Schlage wireless modules are powered locally with 12 VDC power
supply. The modules will transfer a bit stream up to 255 bits from one card reader with any Wiegand, ABA or
custom formatted outputs. The WRI-IN/OUT-12VDC acts as a control interface for third party electric locking
mechanisms such as electric strikes and magnetic locks. The WRI-IN-12VDC communicates to its mating PIM up
to 200’ on the same floor in typical office construction and up to 1000’ line of site.
Performance
Verification Time - Less than 0.10 second (not including panel delays)
Communications (Heartbeat) Interval - Configurable in 1 second increments from 1 second to 18 hours.
Heart Beat can be set to 10 seconds for ARO and MRO operation
Features - Tamper Switch, Door Status Monitoring, Door Strike Relay, Aux Relay, and 2 Reader Head
operation.
Gate Control - WRI /OTD with Optional Long Range Antenna
Addressing - Automatic during RF Linking
Card formats
The WRI-IN/OUT-12VDC accepts card formats up to 255 bits.
Operational environment
Temperature - -35°C to +66°C
Humidity - 20% RH to 95% RH (non-condensing)
Power source
Power Requirements - 12VDC power supply (593PI-12VDC recommended)
Operating Voltage - 7.5 to 14.0 VDC
Radio Frequency (RF) - The PIM includes an RF Transceiver.
Spread spectrum
Direct sequencing spread spectrum
Frequency - 902-928 MHz
Data Rate - 62.5 kbps (half duplex)
Modulo 256 error detection
Selectable channels - 1 of 15 standard; 5 groups of 3 increased interference immunity (configurable)
Approvals - FCC and RSS-210 (Canada)
Transmitter Power - Up to 300mW
Receiver Sensitivity - 90dBM typical
Remote antenna modules - The PIM modules are capable of accommodating Remote Antenna Modules.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vanderbilt lite blue and is the answer not in the manual?

Vanderbilt lite blue Specifications

General IconGeneral
BrandVanderbilt
Modellite blue
CategoryController
LanguageEnglish

Related product manuals