Vatech Smart Plus PHT-35LHS - Page 177

Smart Plus (PHT-35LHS)
Technical Manual
VT-TECH-Smart Plus-001
175 / 188
COPYRIGHT© 2018 VATECH.
ALL RIGHTS RESERVED
(# = 0 : Tube Tilting Disable) – For PANO Only model
(# = 1 : Tube Tilting Enable)
[SPM_TIT?] Request a state of Tube Tilting Type
[SPM_TIPA] Set PANO mode Tube Tilting Position
[SPM_TICE] Set CEPH mode Tube Tilting Position
[SPM_TIFR] Cancel Tube Tilting (Also control Tube Tilting manually)
 Door Lock Control Command
Command Description
[SPM_DROP_000#] Set Door Lock mode
(# = 0: Door Lock mode Disable)
(# = 1: Door Lock mode Enable) - default
[SPM_ISDR] Request a state of Door Lock mode
 Temple Support Control command
Command Description
[SPM_TSMD_000#] Set Temple Support Moving Disable
(# = 0: Temple Support Moving Enable) - default
(# = 1: Temple Support Moving Disable)
 CT Beam Control command
Command
Description
[SPM_CBMD_000#] Set CT Beam Moving Disable
(# = 0: CT Beam Moving Enable) - default
(# = 1: CT Beam Moving Disable)
[SPM_CBCD_000#] Set CT Beam Control Disable in CT mode
(# = 0: CT Beam Control Enable in CT mode) - default
(# = 1: CT Beam Control Disable in CT mode)