50-4 Operation D7x11 Series II Navigator Directional Drill
Transporting the Machine
PREPARING FOR TRANSPORT
Drive machine at a speed suitable for the terrain. Never operate machine faster than you can
comfortably walk. Keep feet clear of the track when driving in reverse. Avoid sudden stopping,
starting or turning unless necessary.
Equipment Components - Stow
Store voltage stake (1) and cable (2) in storage bracket on back of machine.
Store Remote Lockout transmitter in the cradle (3) located inside the engine compartment on the
forward engine bay door. Secure the transmitter in the cradle with the keeper rod and clip.
Drill Rod - Clean and Store
• Clean drill rod with clean water to remove accumulated polymers and dirt.
• Clean and lubricate drill rod threads to prevent rusting. Refer to the Specifications section in
the Maintenance Manual for drill rod thread compound.
• Protect drill rod threads from damage.
• Install rod box cover to protect rod interiors from weather and debris.
WARNING: Rollover possible. Be alert and use extreme caution when
operating on hillsides, or near ditches, gullies, holes, or obstructions
where rollover could occur. Serious injury or death can result if crushed
under the machine. Never allow anyone to be on the downhill side of the
machine. Never allow anyone to ride on the machine.
1
2
3
4_00
To Next Page
Loading...
Need help?
General
