D7x11 Series II Navigator Directional Drill Maintenance 60-1
Section 60: Maintenance
Visually inspect machine daily before starting the machine.
Make no modifications to your equipment unless specifically recommended by Vermeer Corporation.
SAFETY SIGNS MAINTENANCE
Safety signs located on your machine contain important and useful information that will help you operate your
equipment safely. Refer to the Parts Manual and the Controls section for locations.
To assure that all safety signs remain in place and in good condition, follow the instructions given below:
• Keep safety signs clean. Use soap and water - not mineral spirits, abrasive cleaners, or other similar
cleaners that will damage the sign.
• Replace any damaged or missing safety signs. When attaching safety signs, the temperature of the
mounting surface must be at least 40°F (5°C). The mounting surface must be clean and dry.
• When replacing a machine component with a safety sign attached, replace the safety sign also.
• Replacement safety signs can be purchased from your Vermeer equipment dealer.
MAINTENANCE MANUAL
Maintenance Intervals are included for reference only. Before performing any maintenance, refer to the
Maintenance Manual for safety guidelines and correct procedures.
WARNING: Use Shutdown Procedure before servicing, cleaning, repairing, or transporting
machine. Refer to “Shutdown Procedure,” page 50-3, for instructions.
To Next Page
Loading...
Need help?
General
