30-20 Overview D7x11 Series II Navigator Directional Drill
PVC PIPE PULLING (OPTION)
The PVC puller assembly is used to
pull PVC pipe back through the bored
hole. Kits are available for pulling 2, 3,
or 4″ PVC pipe.
Step 1: Assemble pipe lengths (if
more than one) with the PVC puller (1).
Step 2: Pass pull chain (5) through pipe.
Step 3: Assemble PVC puller to backreamer with a clevis pin (2) and cotter pin (3).
Step 4: Connect pull chain to PVC puller with a quick link (4).
Step 5: Pull chain tight between the puller and tensioner (6) with nylon strap (7) and ratchet (8).
NOTE: Use caution when tensioning pipe together to prevent pipe from breaking.
Step 6: Connect tensioner anchor chain to pull chain with a quick link (4).
Step 7: Pull pipe into the bore.
Step 8: After backreaming is complete, release tension on quick link with the ratchet. If ratchet will not
release tension, cut the link with a saw or bolt cutters.
1
2
3
4
5
6
7
8
4
To Next Page
Loading...
Need help?
General
