Vermeer Navigator D7 11 Series User Manual

30-10 Overview D7x11 Series II Navigator Directional Drill
REMOTE LOCKOUT SYSTEM - START
Step 1: Remove battery from charger and install in remote transmitter.
Step 2: Sit in the operator’s seat and turn ignition key to RUN position.
Step 3: Turn remote transmitter on by pressing Power ON/OFF Button and holding for 2 seconds.
Step 4: Press and hold Run Button for 2 seconds to select RUN mode.
Step 5: Follow instructions in “Starting Procedure,” page 50-1.
REMOTE LOCKOUT SYSTEM - SHUT DOWN
IMPORTANT: If the machine is shut down in LOCKOUT mode, the remote transmitter must be available upon
machine start-up to cancel LOCKOUT mode and enter RUN mode.
Step 1: Shut off machine and remove key.
Step 2: Press Power ON/OFF Button and hold for 2 seconds to shut off remote transmitter.
Step 3: Remove battery pack from remote transmitter and install in charger.
Step 4: Place remote transmitter in docking station.

Vermeer Navigator D7 11 Series Specifications

General

Brand	Vermeer
Model	Navigator D7 11 Series
Category	Drill
Language	English