iVent201 Operator's Manual
71
Turning the control knob moves the highlight bar through the
choices. When the desired mode is highlighted, press the knob
to accept it. This will bring up a parameter screen where you
can either accept the default ventilation parameters or change
any of them.
For example, to change to SIMV pressure control mode from
SIMV volume control mode:
1. Make sure you are in the Main
window.
⇒ To return to the Main window, press the clear key on the
keypad below the display. This will cycle you back
through all previous screens until you return to the Main
screen.
2. From the Main screen, turn the
control knob until you highlight
the Mode Selection Box. By
default, the iVent
201
starts in
SIMV Volume Control,
abbreviated “SIMV Vctrl.”
To Next Page
Loading...
