Specifications
TVM Series Installation and Operation Handbook 219
Copyright © 2008, Harris Corporation
Control Specifications
Item Specification
GPI Nine total with four input and five preset recall selections or
individually user configured as alarm input
GPO Two alarms, user configured
Connector 26-pin HD (high density) D-sub, female
Input impedance
10 kΩ returned to +5 VDC
Alarm output Relay closure
Maximum relay current 350 mA @ 30 VDC
External router control One RJ-11 female, for use with Harris RS-12 series routers for future
expansion
Peripheral interface USB 1.1 supporting storage devices, and keyboard
Connector USB 1.1, Type A, female
Display Specifications
Item Specification
General A quadrant display for viewing an input on up to four different
displays as picture, waveform, vector, audio, alarm status, timing,
optional eye pattern, simultaneously or individually as a full screen
display of each separately. Additional data analyzer display for pixel
analysis. Also, view multiple waveform and vectors of the same or
different inputs.
Waveform Composite; YCBCR or RGB, parade/overlay of like formats
Sweep time base
• 1H or 2H with x1, x5, and x10 horizontal magnification
• 1V or 2V with x1, x5, and x25 horizontal magnification
Waveform accuracy ≤ 1%
Eye (optional) Display Eye or waveform individually or paraded
Sweep time base Overlay or 10 Eye (SD), 20 Eye (HD)
Filters 10, 100 Hz, 1 kHz
Vector R-Y vs. B-Y for Analog C
B
vs. C
R
for HD or SD
Vector accuracy ≤ 1°
Gamut Encoded or RGB gamut displays with upper and lower limit selection
Audio (Optional) 2, 4, 6, or 8 channels displayed simultaneously
Time Code Specifications
Item Specification
Input
• LTC via back panel connector
• Ancillary Time Code (HD only)
• DVITC extracted from SD inputs
Display
• Displayed directly
• Used to set internal clock
To Next Page
Loading...