BASIC SAFETY INSTRUCTIONS
16
If worn or damaged parts need replacement, use only •
Wacker Neuson replacement parts to ensure optimum
performance and safety.
Inspect hydraulic hoses and ttings prior to the start of •
each work shift. Correct any observed leaks or abrasion
issues before operating the machine. Extended envi-
ronmental exposure can cause undetectable damage.
Replace hose assemblies periodically as advised in the
maintenance schedule.
Thoroughly inspect the wheel loader before each op-
•
erating shift.
The Wheel Loader Repair Manual describes the special
•
tools, diagnosis techniques, repair sequence proce-
dures, lifting and supporting devices needed to repair this
machine. To avoid unnecessary hazards and possible
damage to the Wheel Loader, do not attempt to repair
this machine without complying with the instructions in
the Repair Manual.
Make the location and means of operation of the re
•
extinguishers known, and consider the options for re
detection and ghting.
A Falling Object Protection System (FOPS) is available
•
for the Wheel Loader Operator Protection System. OSHA
and MSHA require this protection when operating with
overhead hazards. Contact your Wacker Neuson dealer
for advice and availability of a certied FOPS.
To Next Page
Loading...
