OPERATING AND OPERATION
88
Braking and stopping
To change the traveling speed independently of the en-
gine speed, you can push the braking-inching pedal on the
operator’s platform next to the steering column. The rst
part of the pedal‘s path adjusts the travel back down, then
the brake system is actuated. Pushing the braking-inching
pedal allows you to continuously reduce the pump ow
rate until the loader has come to a halt without wearing out
the material. This allows you to also travel very slowly at a
high engine speed.
Reduce the loader‘s traveling speed by decreasing the •
engine speed.
To brake the loader, step on the braking-inching ped-
•
al.
To stop, step on the braking-inching pedal until the loader
•
has come to a stop.
Shift to neutral.•
Pull the lever for the parking brake.•
Loader travel
Release the parking brake after the engine has warmed
•
up.
The handbrake indicator light will go off. The loader is
–
ready to travel.
Select the travel direction by actuating the travel direc-•
tion switch.
The indicator light shows the travel direction selected.
–
You can travel.
Push the accelerator.•
The loader will be brought up to speed smoothly. –
The loader‘s traveling speed is proportional to the accelera-
tor‘s displacement.
low engine speed = low traveling speed•
high engine speed = high traveling speed•
p
To Next Page
Loading...
Need help?
General
