Wacker Neuson WL 50

OPERATING AND OPERATION
86
Changing travel directions
Use the slide switch Item 1 (Fig. 38) to change the loader‘s
travel direction. After the engine has been started, the gear
changer is in neutral position.
Travel direction switch in middle position:•
Gear changer in Neutral –
Push the travel direction switch forward:•
The indicator light – »15« (Fig. 13, page 50) is illuminat-
ed.
The loader travels forward.
Push the travel direction switch back:•
The indicator light – »16« (Fig. 13, page 50) is illuminat-
ed.
The loader travels in reverse.
WARNING
Personal injury and machine damage hazards from
abrupt directional changes. Actuating the direction
switch when the loader is moving will cause the
moving loader to change direction abruptly.
Do not change the travel direction switch posi- ►
tion when the loader is moving in either forward
or reverse.
Before and after changing direction with the ►
loader stopped, conrm that the indicator lights
are in agreement with the intended direction
selected.
If the direction control does not respond or the ►
indicator light does not illuminate, move the ma-
chine to a safe location, lower the loader arms
until the attachment is resting on the ground,
stop the engine and inform the supervisor of a
service need.
Do not operate the loader until a technician ►
has restored the function before operating the
machine.
Be careful when traveling in snowy and icy condi-
tions. Reduce your travel speed considerably in
the event of bad weather.
If the loader is equipped with the optional equip-
ment »Backup alarm for reverse drive«, a backup
alarm sounds when reverse gear is engaged. The
sound is to warn persons who are in the vicinity of
the loader that the loader is going into reverse.