OPERATING AND OPERATION
92
Operating lever for Loader lift arms5. 4 .1
Use the multi-function lever to control the movements of the
loader lift arms Item A (Fig. 39). The multi-function lever is
located on the right next to the operator’s seat.
Keep the loader lift arms and attachment as low
•
as practical when traveling. This improves vis-
ibility and stability, and reduces the risk of strik-
ing overhead objects such as power lines.
Do not activate oat control of the loader arms •
until the bucket or attachment is in contact with
the ground or surface to be back dragged. En-
gaging oat with the lift arms raised will cause
rapid descent of the lift arms.
Do not engage the loader controls unless
•
seated in the operator seat with the seat belt
fastened.
Operate the loader with smooth steady control •
motion. Rapid and jerky control motion is inef-
cient and will cause operator fatigue and cause
potential harm to the loader.
Do not leave the operator seat until the loader •
lift arms and attachment have been lowered to
the ground.
The loader lift arms oat position is located on the
»Lower« and »Tilting out« function. When
the multi-function lever is released, it automati-
cally returns to the neutral position (except when
in oat position).
To Next Page
Loading...
