OPERATING AND OPERATION
83
WL50
If the engine does not start
Attempt to start the loader for a maximum of 20 sec-
•
onds.
Wait one minute.•
Repeat the starting process.•
If the engine will not start after two attempts, look for
•
the cause in the malfunction table (»Troubleshooting
and emergency maintenance«) or contact a specialist
garage.
It is absolutely not possible to start the engine by
tow-starting the loader. This could damage the hy-
draulic system.
Preheating
You can preheat the engine to make the starting process
at lower temperatures easier.
The heating process is automatically activated when
1.
level I is switched on.
The heater indicator light Item 1 (Fig. 132. ) lights up.
Start the engine at level III as soon as the heater indica-
3.
tor light goes out.
To Next Page
Loading...
