SuperRack SoundGrid / User Guide
MIDI Control Changes for Snapshots
The Snapshots list can be controlled with MIDI program changes. Use the MIDI control panel to set up Follow
Program Change or Generate Program Change commands (Setup > System Inventory > Controllers > Device
Control Panel).
Assigning Remote IDs to Snapshots
You can manually assign a remote ID number to a snapshot. This lets you separate the listing order of the
snapshots in the Snapshots List from the remote-control snapshot ordering.
If, for example, you assign snapshot number 5 the remote ID of 130, and in the MIDI Controller you assign CC
Number #7 to the 129-256 range, then this MIDI CC #7 with value 1 will recall snapshot 130 (value 0 will recall 129,
and so forth).
There are two ways to assign a remote ID to a snapshot:
When you initially name a snapshot, you can assign an ID using the
External ID drop-down menu.
A new snapshot will indicate the external ID as “none.” To assign an external ID to a
snapshot that’s already in the Snapshots List, click on the arrow to open the
assignment drop-down menu.
To Next Page
Loading...
Need help?
General
