7. Standby flush – activates or deactivates the standby flush during switching off, value must
not be modified.
8. Water tank operation – activates or deactivates the option water tank, value must not be
modified.
9. Stop when water tank empty – activates or deactivates the remaining water quantity func-
tion („remaining water quantity“see tab parameters), value must not be modified.
10. Preventive maintenance request – activates or deactivates the display message „service rec-
ommended“if preventive maintenance request is reached, value must not be modified.
11. Enforced cleaning – activates or deactivates enforced cleaning; if enforced cleaning is acti-
vated the coffee machine must be cleaned after a specific enforced cleaning value has been
reached; otherwise the machine will not be ready to operate. Value must not be modified.
12. Steam boiler installed – activates or deactivates the steam boiler and thus the milk / milk
foam dispensing, value must not be modified.
13. Cappuccinatore installed – Must be activated if milk foamer system is in use, value must not
be modified.
14. Steam boiler pressure release during heating up – Must be activated, then it is granted
that the overpressure during heating up can escape from the steam boiler, value must not be
modified.
15. Steam burst for purging condensate – activates or deactivates the pre-heating function of
the milk system and purging of the steam hoses, value must not be modified.
16. Machine locked until both boilers have heated up – If this option is set the coffee machine
is only ready to operate if both boilers are on temperature, value must not be modified.
17. Lock machine if brew water temperature low – If this option is set the coffee machine is
always locked when the hot water boiler temperature drops below the set brew water temper-
ature, value must not be modified.
To Next Page
Loading...
