WMF 800 - Button Programming > Load > Sys > Care;Maintenance

9 Button Programming > Programming 47
9.2.2 Button Programming > Load > Sys > Care/maintenance
5. System configuration – „Sys“ – Care / maintenance
1. Cleaning prompt / days – No. of days until coffee machine cleaning is required, value
must not be modified.
2. Forced cleaning / days – No. of days until forced cleaning („.Forced cleaning“ see tab
options), value must not be modified.
3. Cleaning prompt / cups – No. of brewings until coffee machine cleaning is required,
value must not be modified.
4. Forced cleaning / cups – No. of brewings until forced cleaning („Forced cleaning“ see
tab options), value must not be modified.
5. Delay cleaning prompt / cups – No. of cups until forced cleaning is displayed again,
value must not be modified.
6. Water volume rinse piston – rinsing volume during warm rinsing, value must not be
modified.
7. Waiting in the rinsing phase – waiting between rinsing intervals, value must not be
modified.
8. Repetition of brewer rinsing cycles – No. of rinsing intervals, value must not be mod-
ified.
9. Preventive maintenance prompt – No. of brewings after which the message „Service
recommended“is displayed, value must not be modified.
10. Milk system rinse delay – indicated the time until „Milk system rinsing“is demanded,
value must not be modified.
11. Water volume - rinse milk system – rinsing volume of milk system rinsing, value
must not be modified.