WMF 800 - Button Programming > Load > Sys > Options

9 Button Programming > Programming 45
12. Current (repress) – Value must not be modified
13. Discharge after beverage – Shows the time during which the release valve remains open
after brewing, value must not be modified
14. Discharge after cleaning – Shows the time during which the release valve remains open
after cleaning, value must not be modified
9.2.1 Button Programming > Load > Sys > Options
4. System configuration – „Sys“ – Options
1. Enable beep – activates or deactivates the beep when button is pressed, value can be
changed
2. Mains voltage 110/120V – activates the modified heating management for countries with
100 – 120 V mains voltage
3. Decaffeinated function lock – activates or deactivates the control of the manual insert lid,
value must not be modified.
4. Programming enabled while heating – activates or deactivates the programming menu dur-
ing the heating phases, value must not be modified.
5. Erase counters protected by PIN Code – this function is not supported.
6. Startup flush – activates or deactivates the startup flush during switching on, value must not
be modified.