4 Software update 18
In order that the coffee machine is ready to operate again after the software update, there are
two possibilities:
1. possibility – directly in the Hex-Load program
Through „Target“ -> „Start Program“ boot coffee machine again
Afterwards close „File“ -> „End“ HexLoad program
2. possibility – directly at the coffee machine
Switch coffee machine OFF/ON
Disadvantage: By using this method the communication between coffee machine and
service program is interrupted and has to be started again.
4.3 Workflow description through „Software download“
A transfer of software through „Software download“ is only possible and necessary if:
During the software update (chapter 4.1) an error has occurred (e.g. caused by an interrupted connection), or the coffee machine is still in the
bootloader mode (see coffee machine display) despite switching it off/on as on the CPU the software is only partly available or completely unavaila-
ble.
There is no software on the CPU
Through „Extras“ -> „Flash Programmer“ -> „Software download“ start downloading software again.
To Next Page
Loading...
