22. Pre-infusion – indicates whether the ground coffee should be watered in the brewing
chamber prior to the actual brewing process which makes the coffee taste more intensive,
value should only be modified at the coffee machine.
23. Pre-heat cappuccinatore – activates or deactivates a short steam jet in order to pre-
heat the milk system, value must not be modified.
24. Wet pressing, after pre-infusion – activates or deactivates the function that the tamp-
ing pressure of the brewing chamber is slightly increased after pre-infusion (see 22), value
must not be modified.
25. Wait until milk dispensing finished – this function is controlled by „Milk foam before
coffee“ (see 16), value must not be modified.
26. Beverage with milk foam – activates or deactivates the control whether the all-in-one
spout is in the upper position upon demand of milk foam dispensing, value must not be
modified.
27. Assign defined product name – an earlier defined beverage name can be selected here
(see chapter 3.2.1), value should not be modified.
28. Return to standard value –all parameters can be reset here to their original default val-
ues here (saved in the factory setting memory).
29. Cup size – Coffee volume dosage – 2 cups size – only indicated values in the display,
these values cannot be modified
To Next Page
Loading...
