WMF 800 - Page 13

Engin eering
© WMF800 / 900 / 1000S / 1000proS Edition 07/2014 - KMT
T2-2
2/1.1 Grinder
The motor makes contact with the
absorber. It serves to prevent rotation
and for damping out noise.
If the grinder is defective, it must be
completely replaced. The adjustment
rod can be removed beforehand, and
reinstalled on the new grinder.
Spare parts
• Grinder disk set
• Grinder ground coffee spout
• Complete grinder
• Adjustment drive
Setting the grinding degree of the grinder
The upper grinder knife can be adjusted axially with athreaded screw. This has
atake-up part with outer threads for the upper grinder knife. Asetting pin grips the
outside toothed gear, which attaches the multitool and can be set by turning to press
down.
The setting pin is arranged in the bean hopper.
• Turn clockwise: coarser
• Turn counter-clockwise: finder
• Range of settings: 7AM to 5PM
• Grinding opening: 0.084mm to 0.42mm
• Standard setting when delivered: about 11AM
Caution: grinding degree is set only during grinder operation.
Error messages on the display
• Grinder blocked
3
17
23
A
See instructions, error messages, troubleshooting,
part 6.
grinder blocked