WMF 800 - Page 15

Engin eering
© WMF800 / 900 / 1000S / 1000proS Edition 07/2014 - KMT
T2-4
Technician instructions
• If the grinder is faulty, the complete grinder must be replaced
• The idle current recognition must be entered in the service program if the grinder
is replaced
• If the grinder disks must be replaced or the grinder opened, the grinder must be
brought to the base position before putting back into operation.
• If the grinder has been replaced or new grinder disks have been installed, the
counter must be set to zero using the service program.
See Chapter 5/2.5.3
“Carry out Service Maintenance” part 6.