To Next Page

To Previous Page

Firmware update inoLab

Multi 9620 IDS

136 ba77173e04 12/2017

17 Firmware update

17.1 Firmware update for the meter Multi 9620 IDS

You can find available firmware update files for your meter on the Internet. With

the "Firmware Update " program and a PC you can update the firmware of the

Multi 9620 IDS to the newest version.

For the update you have to connect the meter to a PC.

For the update via the USB-B interface, the following is required:

 a free USB interface (virtual COM port) on the PC

 the driver for the USB interface (on the enclosed CD-ROM)

 the USB cable (included in the scope of delivery of the Multi 9620 IDS).

After switching the meter off and on you can check whether the meter has taken

over the new software version (see Y

OU WANT TO KNOW WHICH SOFTWARE

VERSION IS IN THE METER OR IDS SENSOR, PAGE 130).

1. Install the downloaded firmware update on a PC.

An update folder is created in the Windows start menu.

If an update folder already exists for the meter (or meter type), the new

data are displayed there.

2. In the windows start menu, open the update folder and start the firm-

ware update program for the meter

3. Using the USB interface cable, connect the Multi 9620 IDS to a USB

interface (virtual COM port) of the PC.

4. Switch on the Multi 9620 IDS.

5. In the firmware update program, start the update process with OK.

6. Follow the instructions of the firmware update program.

During the programming process, a corresponding message and a

progress bar (in %) are displayed.

The programming process takes up to 20 minutes. A terminatory mes-

sage is displayed after a successful programming process. The firm-

ware update is completed.

7. Disconnect the Multi 9620 IDS from the PC.

The Multi 9620 IDS is ready for operation again.

wtw inoLab Multi 9620 IDS User Manual

Questions and Answers: