wtw inoLab Multi 9620 IDS User Manual

Settings inoLab
®
Multi 9620 IDS
98 ba77173e04 12/2017
You can change the interval (1 ... 999 days):
11.2 ORP measurement settings
Settings The settings are made in the menu for measuring settings of the ORP measure-
ment. To open the settings, display the required measured parameter in the
measured value display and press the <ENTER> key. After completing the set-
tings, switch to the measured value display with <M>.
Default settings are printed in bold.
11.3 ISE measurement settings
The settings are made in the measuring menu of the ISE measurement. To
open the settings, activate the relevant measuring window in the measured
value display and press the <ENTER> key shortly
. After completing the set-
tings, switch to the measured value display with <M>.
The following settings are possible for ISE measurements:
1. Open the menu for measurement settings with <ENTER>.
2. In the Calibration / Calibration interval menu, set the calibration interval
with <><>.
3. Confirm the setting with <ENTER>.
4. Quit the menu with <M>.
Menu item Possible setting Explanation
mV resolution 0.1
1
Resolution of the mV display
Reset - Resets all sensor settings to the
delivery condition (see section
11.8.1 R
ESETTING THE MEASURE-
MENT SETTINGS, page 108).
Menu item Possible setting Explanation
Calibration /
Calibration record
- Displays the calibration
record of the last calibration.
Calibration /
Calibration data stor-
age /
Display
- Displays the last calibration
records (max. 10)
Calibration /
Calibration data stor-
age /
Output to RS232/
USB
- Outputs the calibration
records to the interface.

wtw inoLab Multi 9620 IDS Specifications

General

Brand	wtw
Model	inoLab Multi 9620 IDS
Category	Measuring Instruments
Language	English