wtw inoLab Multi 9620 IDS User Manual

Settings inoLab
®
Multi 9620 IDS
108 ba77173e04 12/2017
11.8 Reset
You can reset (initialize) all sensor settings and sensor-independent settings
separately from each other.
11.8.1 Resetting the measurement settings
pH The following settings for pH measurements are reset to the default settings
with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the <ENTER>
key.
ORP The following settings for ORP measurements are reset to the default settings
with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open the settings, display the required
measured parameter in the measured value display and press the <ENTER>
key.
The calibration data are reset to the default settings together with
the measuring parameters. Recalibrate after performing a reset.
Setting Default settings
Buffer TEC
Calibration interval 7 d
Unit for slope mV/pH
Measured parameter pH
pH resolution 0.001
mV resolution 0.1
Asymmetry 0 mV
Slope -59.2 mV
Man. temperature 25 °C
Single-point calibration off
Setting Default settings
mV resolution 0.1
Man. temperature 25 °C

wtw inoLab Multi 9620 IDS Specifications

General

Brand	wtw
Model	inoLab Multi 9620 IDS
Category	Measuring Instruments
Language	English