Operation inoLab
®
Multi 9620 IDS
20 ba77173e04 12/2017
Changing the pass-
word
If the administrator has set up the access with password protection:
2. Using <><>, select the menu item, User name and confirm with
<ENTER>.
The user name is highlighted.
3. Using <><>, select a user name and confirm with <ENTER>.
The login is done immediately if no password is required.
If a sensor is connected the measured value display appears.
4. If a password is required:
Using <><>, select the menu item, Password and confirm with
<ENTER>.
The user specifies the password when he or she first logs in with a
user name.
A valid password consists of 4 digits.
The user can change the password with the next login.
5. Change the digit of the highlighted position with <><>.
Switch to the next position of the password with <><>.
When the password was completely entered, confirm with <ENTER>.
The login takes place. If a sensor is connected the measured value dis-
play appears.
User name Admin
Password ####
Change password
Login
01.09.2017 08:00
1. Switch the meter on with <On/Off> (or <On/Off_>).
The Login dialog appears.
2. Using <><>, select the menu item, User name and confirm with
<ENTER>.
The user name is highlighted.
3. Using <><>, select a user name and confirm with <ENTER>.
4. Using <><>, select the menu item, Change password and confirm
with <ENTER>.
To Next Page
Loading...
Need help?
General
