July 2019
2-13
Xerox® B210 Service Manual
09-800 , 09-600, 09-900
Status Indicator RAPs
Initial Release
09-800 Incompatible Toner Cartridge RAP
The Toner Cartridge is not compatible with the printer.
Procedure
1. Verify the Toner Cartridge is a Genuine Xerox
®
Toner Cartridge.
2. Print a Supplies Information Report, GP
2.
3. Check the Toner Cartridge information. Install a new Toner Cartridge if is not a genuine
Xero
x
®
cartridge.
09-600, 09-900 Imaging Unit RAP
BSD-ON:BSD 1
The Imaging Unit has not been installed or machine software is unable to detect the Imaging
Unit
.
09-600
Imaging Unit Not Installed.
09-900
Imaging Unit Invalid
Initial Actions
• Ensure that a genuine Xerox Imaging Unit has been installed.
• Switch off, then switch on the machine.
Procedure
WARNING
Do not perform repair activities with the power on or electrical power supplied to the
machine. The machine could activate and cause serious personal injury when the power
is on or electrical power is supplied.
DANGER: Ne pas effectuer de dépannage avec le contact principal activé ou avec l'ali-
mentation électrique appliquée à la machine: celle-ci pourrait démarrer et causer de
g
raves blessures.
AVVERTENZA: Non effettuare alcuna riparazione con la macchina accesa o con l'ali-
mentazione elettrica inserita. La macchina potrebbe avviarsi all'improvviso e causare
gr
avi ferite.
VORSICHT: Es dürfen keine Reparaturarbeiten durchgeführt werden, solange das Gerät
ei
ngeschalten oder mit der Stromquelle verbunden ist. Das Gerät kann u.U in den Aktiv-
Zustand übergehen und somit erhebliche körperliche Schäden verursachen.
AVISO: No realice reparaciones con la máquina encendida o conectada a la corriente. La
máqui
na podría activarse y ocasionar daños personales graves.
1. Switch off the machine.
2. Remove the Imaging Unit.
3. Check the CRUM contact area for contamination and clean if necessary.
4. Reinstall the Imaging Unit.
5. Check the contacts on the HVPS.
6. If the fault persists, install a new Imaging Unit.