Repair Analysis Procedures
Phaser® 3500 Laser Printer Service Manual
2-5
Service Diagnostics Menu Map
Service Diagnostic Control Panel Button Descriptions
Button Function
BACK Returns to the prior higher level menu structure, if available.
Stops the actively running test.
CANCEL Terminates the current test.
MENU Cycles through all of the top level menu items.
UP Scrolls up one menu item within a menu list. This control does not ‘wrap’.
Used to increment values in tests requiring user input.
DOWN Scrolls up one menu item within a menu list. This control does not ‘wrap’.
Used to increment values in tests requiring user input.
OK Enters the highlighted menu. Executes the current test item.
Used to select the value entered by the user.
Main Menu Sub Menu Description/Function Control Panel Display
Optins
Interface
Tray 3
Interface
Tests the interface between
the main controller and the
Tray 3 interface board.
Tray 3 Interface:
Pass /Fail :x.x.x
Duplex
Interface
Tests the interface between
the main controller and the
duplex interface board.
Duplex Interface
Pass/Fail :x.x.x
Test
Pattern
Simplex Prints the test print page in
simplex mode. The Control
Panel will display the papers
location during the print
process.
This process will print
continuosly until stopped by
the user.
Simplex Print
Start -> Feed On -> Exit On
Duplex Prints the test print page in
2-sided or duplex mode.
This process will print
continuosly until stopped by
the user.
Duplex Print
Start -> Feed On -> Exit On -> Duplex
On
Motor/Fan Main Motor Main drive motor runs when
the OK button is pressed
and stops when the Cancel
button is pressed.
Main Motor
Running Test
ON/OFF
To Next Page
Loading...
