Parts List
Phaser® 3500 Laser Printer Service Manual
5-2
Using the Parts List
1. No.: The callout number from the exploded part diagram.
2. Part Number: The material part number used to order specific parts.
3. Qty: This number represents the parts per printer, not the number of parts supplied in the
actual part order.
4. Name/Description: Details the name of the part to be ordered and the number of parts
supplied per order.
5. Parts identified throughout this manual are referenced PL #.#.#; For example, PL 3.1.10
means the part is item 10 of Parts List 3.1.
6. A black triangle preceding a number followed by a parenthetical statement in an illustrated
parts list means the item is a parent assembly, made up of the individual parts called out in
parentheses.
7. The notation “with X~Y” following a part name indicates an assembly that is made up of
components X through Y. For example, “1 (with 2~4)” means part 1 consists of part 2, part
3, and part 4.
8. An asterisk (*) following a part name indicates the page contains a note about this part.
9. The notation (NS) next to a part indicates that pariticular part is not spared, but contained
in a kit or major assembly.
10. The notation “J1<>J2 and P2” is attached to a wire harness. It indicates that connector
Jack 1 is attached to one end of the wire harness and connector J2 is attached to the other
end that is plugged into P2.
Only parts showing part numbers are available for support. Parts not showing part
numbers are available on the parent assembly.
Legend:
Identifier Meaning
CC-ring
EE-ring
KL K-clip
SScrew
To Next Page
Loading...
