Xerox Phaser 3500 - Main Drive Assembly and Registration (Feed) Clutch; Feed Clutch

Repairs and Adjustments
Phaser® 3500 Laser Printer Service Manual
4-24
Main Drive Assembly and Registration (Feed)
Clutch
1. Remove:
■ Covers on page 4-4
Feed Clutch
1. Loosen the grounding bracket screw attached to the plate on the Main Drive Assembly,
and rotate the grounding bracket to gain access to the e-ring.
2. Remove the e-ring securing the clutch to the feed roller shaft.
3. Disconnect the connector to the connector board, and remove the clutch from the printer.
Clutch
E-Ring
s3500-073