08/2012
6-91
WorkCentre 5021/5019
6.4.2.1.1
General Procedures
Initial Issue
6.4.2.1.1 Initialize Fault History
Purpose
Initialize the Fault History.
Check the completed [Initialize Fault History] at the [System Fail History] of [ERROR History
Report].
Procedure
1. Enter the CE Diag Mode and input 998-980 in the Chain-Link.
2. Pressing the [Start] button transitions to the [Check Initialization] screen. At this time, the
[CLR] and the [Start] button will be flashing.
Figure 1 j0lj64003
3. Pressing the [Start] button starts the initialization of the [Fault History].
• An animation will be displayed to indicate that it is in progress.
Figure 2 j0lj64004
4. When the initialization has completed successfully, [End] will flash twice -> remain ON to
indicate the completion of the [Fault History] initialization.
5. Pressing the [Clear All] button returns you to the [Chain-Link Number Entry] screen.
To Next Page
Loading...
