08/2012
6-104
WorkCentre 5021/5019
6.4.2.13, 6.4.2.14
Initial Issue
General Procedures
Figure 2 j0lj64012
5. After the last paper is output or when the [Stop] button is pressed, [End] will be displayed
on the UI.
6. Pressing the [Clear All] button returns you to the [Chain-Link Number Entry] screen.
6.4.2.14 Test Pattern Print
Purpose
Performs copy quality check by printing the Test Pattern in the machine.
Procedure
1. Enter the CE Diag Mode.
2. Input the Chain-Link No. of the Test Pattern to be output and press the [Start] button to
transition to the [Print Test Pattern Settings] screen.
NOTE: The 24 Gradation Density Pattern (998-905 and 998-906) can only be output on
A3.
3. The default values for the setting screen are - Quantity: 1, Tray 1, and 1 to 1 Sided.
4. Select the [Quantity], [Paper Supply] and [2 to 1 Sided].
NOTE: The Quantity can be specified up to 2 digits, with the maximum of 99.
5. Pressing the [Start] button outputs the test pattern. An animation will be displayed to indi-
cate that it is being output.
Figure 1 j0lj64012
Table 1
Chain-Link Type Overview
998-901 Blank Image Outputs a blank printout.
998-902 Solid black Outputs a solid black printout.
998-903 Stripe Outputs a black and white stripes print-
out.
998-904 Grid Pattern Outputs a grid pattern printout.
998-905 24 Gradation Density Pattern (A3)
(ATCN24KED)
Outputs a 24 gradation density pattern
(ATCN24KED) printout.
998-906 24 Gradation Density Pattern (A3)
(ATCN24KDI)
Outputs a 24 gradation density pattern
(ATCN24KDI) printout.
To Next Page
Loading...
