9-154
P0335
5. Defective crankshaft position sensor.
• Check the crankshaft position sensor.
Refer to “CHECKING THE CRANKSHAFT POSITION SENSOR” on page 8-60.
6. Malfunction in ECU.
• Replace the ECU, and complete the service.
Refer to “REPLACING THE ECU (Engine Control Unit)” on page 8-56.
7. Delete the DTC and check that the MIL goes off.
• Confirm that the DTC has a condition of “Recovered” using the YDT, and then delete the DTC.
Is check result OK?
YES
→ Go to step 6.
NO
a. Replace the crankshaft position sensor.
b. Crank the engine, and then check the condition of the DTC using the malfunction mode of the
YDT.
Is it in the “Recovered” condition?
YES
→ Go to step 7, and complete the service.
NO
→ Go to step 6.
To Next Page